Description
THIS SYSTEM ONLY WORKS WITH OUR NETS BECAUSE OF OUR UNIQUE FRAME DESIGN AND PLEASE NOTE THAT WE DO A FREE FITTING SERVICE WHEN BOUGHT WITH ONE OF OUR NETS.
FITTING INSTRUCTIONS FOR MAGNETIC RELEASE SYSTEM.
REMOVE THE NET FRAME RETAINING SCREW WITH A FLAT HEAD SCREWDRIVER.
REMOVE ONE SIDE ONLY OF THE NET FRAME AND SLIDE THE LOWER PART OF THE MAGNET SYSTEM ONTO THE FRAME. AT THIS POINT RE-ASSEMBLE YOUR NET FRAME INTO THE HOLDER AND TIGHTEN THE RETAINING SCREW.
POSITION YOUR MAGNETIC RETAINER ON THE FRAME. IN THE CASE OF OUR WEIGH NETS WE RECOMMEND THE CENTRE OF THE NET DUE TO THE SLIGHT ADDITIONAL LENGTH OF THE HANDLE. WITH OUR OTHER RIVER NETS THE CHOICE IS YOURS. WHEN YOU HAVE SELECTED YOUR POSITION, CUT ONE STRAND OF THE NET BAG TO PULL OVER THE RETAINER SECTION.
AT THIS POINT TIGHTEN THE RETAINING STEEL SCREW NICE AND TIGHTLY ONTO THE FRAME OF THE NET.
OUR NET BAGS ARE NON FRAY SO ITS PERFECTLY FINE TO CARRY OUT THIS PROCEDURE. HOWEVER AS A BACK UP, AND AS CAN BE SEEN IN THE ATTACHED PHOTO, WE WOULD RECOMMEND A SMALL DROP OF SUPERGLUE OR SIMILAR ONTO THE CUT PARTS FOR EXTRA PEACE OF MIND.
ASSEMBLE THE MAGNETIC SYSTEM AND ATTACH THE UPPER STEEL BOW SHACKLE TO YOUR JACKET OR WAISTCOAT AND YOU’RE READY TO GO…………………………..